Portamatrículas HIGHSIDER pro

HIGHSIDER pro license plate holder incl. license plate light

The HIGHSIDER pro license plate holder adapts perfectly to the lines of your bike thanks to its design.

The model-specific bracket of the HIGHSIDER pro allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. The precise cutting is done by laser. After edging, a weather-resistant black powder coating is applied.
This ensures an optimum fit and durability.
The infinitely variable adjustment option allows you to move the panel to the desired position without drilling. There is an additional locking screw to hold the plate in this position.

The blinker brackets of the HIGHSIDER pro are adjustable in width and therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates.

You can also adjust the position of the rear reflector individually using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate and reduce vibrations. Another rubber buffer supports the license plate on its underside.

This PRO version of the HIGHSIDER pro includes the very small HIGHSIDER license plate light milled from high-quality aluminium with mounting plate and support arm. The bracket is height-adjustable and designed so that it can be mounted in the legally prescribed position.

Details:

- model-specific bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable angle of inclination
- additional screw for optimum positional security
- easy fixation without further work steps (e.g. drilling)
- easy mounting thanks to elongated holes
- license plate light incl.e.g. drilling)
- easy mounting of the license plate thanks to slotted holes
- license plate light incl. holder included
. bracket included
- license plate light, E-approved
- infinitely adjustable license plate light
- many different options for attaching the license plate light

The scope of delivery of the HIGHSIDER pro includes:

- Model-specific bracket with mounting parts
- HIGHSIDER AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable bracket
- E-approved license plate light
- Installation instructions

Notes:
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- Special blinker holders are optionally available for the original indicators.

Tip:
If you have not found a model-specific license plate holder for your vehicle, then you are sure to find what you are looking for with the universal license plate holders from HIGHSIDER, which are available in many different designs.